NOTE: First, remove any oxidation and staining before application.
Clean the surface thoroughly with an isopropyl alcohol and water mixture 50/50, to remove any debris or lint from the surface.
Shake (Step #2) bottle well and then apply 3-4 drops of Platinum Ceramics to microfiber applicator. Start with a 2’ X 2’ square section and wipe left to right and then going in a cross directional pattern until product is overlapped evenly.
Once the product has flashed and appears not to be wet, thoroughly wipe the panel with a microfiber towel to create a flat even finish.
Move to the next section and repeat.
To layer Platinum, allow 1 hour between coats. Applicator pads and microfiber towels should be rinsed out in water, squeezed out, bagged and disposed of properly.
FLAMMABLE LIQUID AND VAPOUR. HARMFUL IF SWALLOWED CAUSES SKIN IRRITATION. CAUSES SERIOUS EYE IRRITATION SUSPECTED OF DAMAGING FERTILITY. MAY CAUSE LONG LASTING HARMFUL EFFECTS TO AQUATIC LIFE.
Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Wear protective gloves / protective clothing / eye protection / face protection.
FIRST AID: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. IF EXPOSED OR CONCERNED: Get medical advice / attention. If eye irritation persists: Get medical advice / attention. IN CASE OF FIRE: Use sand, carbon dioxide or powder extinguisher to extinguish.
Store in a well-ventilated place. Keep cool. Dispose of contents / container in accordance with local / regional / national / international regulations. This product contains Octamethylcyclotetrasiloxane Polysiloxazane resin.
IN CASE OF EMERGENCY CALL:
Infotrac US: 1.800.535.5053
Infotrac EU: 1.352.323.3500